Windows 95 prompts you to restart the PC.Windows XP, XP 64-bit, Vista, Vista 64-bit, 7, 7 64-bit, 11, 10, 8, 8.1ģCom EtherLink 10/100 PCI For Complete PC Management NIC (3C905C-TX) Windows drivers were collected from official vendor’s websites and trusted sources. When the previous steps are finished, click OK.Enter your domain name into the Domain Suffix Search Order box and click on Add.Repeat the same procedure with 128.171.1.1. Enter 128.171.3.13 into the DNS Server Search Order box and then click on the Add button.Later after you found out the correct host and domain names for your computer from ITS. Names are unknown, you can temporarily name them any words, then change them Select DNS Configuration and select the Enable DNS box.The first three numbers of your IP address and the last number is usually '1',Į.g., if your IP address is 128.171.47.254, your gateway address usually willīe 128.171.47.1. In the gateway address, in most cases, the first three numbers are the same as * If two or more TCP/IP installed, make sure to click on the one with the NIC name that you will be using.Īnd subnet mask, in most cases your IP willīe similar to and subnet mask will be 255.255.255.0. NIC Adapter(the above graphic lists a 3Com Etherlink III ISA NIC, your NIC may be different) ( Figure 1) Your window may look slightly different The default Microsoft network setup contains the following components: For Microsoft networks, select the Configuration tab.In the Control Panel, double-click Network.Open the Windows 95 Control Panel (Start button | Settings | Control Panel).If Windows prompts you to reboot, click No. Enter the correct path to the Windows files (CAB files) and click OK.Once the installation files are read, Windows prompts you for the Windows 95 network installation files. Otherwise, supply the correct drive letter and click OK. Insert diskette containing NIC driver in your drive and, if the diskette is in drive A, click OK.Select Driver from disk provided by hardware manufacturer and click OK.Windows automatically detects the NIC in the PC. Insert NIC into slot and secure with a screw.

Open up the PC and find an open bus slot. Install the NIC and connect it to the network cable.Install and configure Windows 95/98 before installing.If the Network Interface Card (NIC) is already installed go to step 7.įollow these steps to install the network driver in a PC running Windows 95/98: If aĬomputer person is available, please consult with him or her before proceeding. This procedure requires some technical knowledge as it changes the network settings. Intermediate.HardĪlways backup your data prior to making any configuration changes. TCP/IP is the computer protocol needed to access the internet

3com etherlink iii driver windows 10